1. Before assembly, make sure the correct installation of the sealing film. Slight damage to the film seal with adhesive tape, with large cracks, replace the film. A warning The plant holder armrest riveting fastening only after installation of the film. When replacing the film cut out the area and seal overlap or seal the adhesive tape.
|
2. Place the wire connector. |
3. Insert the actuating mechanism inside the door and lock it. |
| 4. Replace damaged spring clips. Install the inner liner on top of the door lock button, enter into the tire to seal simultaneously with spring clips in holes in the sheet metal door. |
5. Push the inner lining of the door with his fists in the spring clips. |
6. Screw the screw with a Phillips head below the armrest. Apply coating. |
7. Screw the control of the door from the inside with two screws. Place the handle shell. |
| 8. puck gap (3) set the window handle large diameter to the door trim. |
9. Push the handle on the axle. In the open window, the handle must be directed diagonally forward upward. |
10. Slide the bottom shell (1) on the handle (2), wherein the track, so that the head cladding groove entered on the axis of the handle. Slide the cover forward so as not will engage the locking hooks (arrow). |
11. Lift up the glass with the handle. |
12. Insert the trim for the door lock on top and bottom tighten the screw. |