REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz M-Class (W163, 1997 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	W163
		Introduction
		Controls and receptions of safe operation
		Current care and maintenance
		Engine
			Check the compression pressure in the cylinders
			Checking the engine by means of the vacuum gauge
			Replace accessory drive belt and its tension elements of the mechanism
			Petrol models
			Diesel models
				Removing and installing engine
				Removal and installation of covers of timing
				Replacing the gas distribution chain
				Removal and installation of components of timing
				Setting up the base camshaft
				Checking the reference position of the balancing shaft (only engines Series 628)
				Removal and installation of components of timing
				Removal and installation of a head (s) of cylinders
				Removal and installation of the motor off the inlet port (612 series engine)
				Removing and installing exhaust manifold
				Replacement of a forward epiploon of a cranked shaft
				Removing and installing rear end cover, replace the crankshaft rear oil seal
				Removing and installing vibration damper / belt pulley
				Removal and installation of a flywheel / drive disc
				Removal and installation of supports of the suspension of the power unit
				Service lubrication systems
		System of cooling, heating and air conditioner
		The power supply system and exhaust
		Systems of an electric motor
		Manual box of a gear change
		The transmission automatically processed
		Transmission Line
		Brakes and auxiliary systems
		Suspension and steering
		Body
		Onboard electric

printable version

Removal and installation of the motor off the inlet port (612 series engine)

Details of installation of the motor inlet port of the engine shutdown Series 612

PERFORMANCE ORDER
Details of installation of the motor off the inlet port on the 612 series engines are shown in the illustration, which includes all the links in the text.
Remove the diffuser.
On models with Manual transmission remove the left front wheel.
On models with Manual transmission locker remove wheel arch protection.
Remove the screws (1).
Release the latch and lift the spacer (3) of the ball head (2).
Disconnect the connector (4) electrical motor (M55).
Remove the motor assembly (M55) with air distribution pipe (5).
Installation is in the reverse order.
Finally, clean the memory module on-board self-test (see chap. Systems of an electric motor).

« previos page
Removal and installation of a head (s) of cylinders

next page »
Removing and installing exhaust manifold