add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz C-Class (W203, 2000 issue)

general info. full specifications. diagnostics. hints. tips. tricks
Mercedes-Benz W203
Home
 
Mercedes-Benz
W203
Introduction
Instruction Manual
Routine maintenance
Engine
Cooling and heating
The power supply system and release
Electric motor
Manual gearbox
Automatic Transmission
Coupling and power shafts
Brakes
Suspension and steering
Body
Onboard electric
Specifications
Fault diagnosis onboard electric equipment - the general information
Check the wiper motor
Check heated rear window
Relays and fuses
Replacing incandescent exterior lights
Replacing bulbs Interior lighting
Removing and installing daylight sensor
Removing and installing lights
Removing and installing fog
Removing and installing the lens fog
Removing and installing the rear light
Replacing the battery ignition key / remote control
Removing and installing windscreen wiper motor
Removing and installing rear window wiper motor
Removal and installation of the water tank and pump motor
Removal and installation of a rain sensor
Removal and installation of the audio signal
Removing and installing parking sensors
Removing and installing ambient temperature sensor
Removing and installing dashboard
Removal and installation of stalk
Removal and installation of the switch of the front canopy on the ceiling
Removal and installation of the group switches to the left of the control panel
Removing and installing center console switch
Removal and installation of switches in the door
Removal and installation of door switches the interior lighting
Removal and installation of warning signs parking assistant
Removing and installing cigarette lighter
Removal and installation of the radio
Removal and installation of loudspeakers
The digital CAN data bus
The uniform lock - general information
Installation of additional electric and electronic devices
Function and location of electrical connectors
Diagrams
 


Hit Counter by Digits


print page printable version

Removing and installing fog



Withdrawal

PERFORMANCE ORDER

1. Disconnect the negative (-) cable of the battery when the ignition is off. You must first remove the air filter box of the passenger compartment.

Before disconnecting the cable, find out the radio security code, if any, address to Section Replacement of the battery.

2. Remove the front locker, address to Section Removal and installation of a forward wing locker.
3. Disconnect the fog lamp connector.
4. Driver's side: Turn the lamp holder anticlockwise and remove it.
5. Driver's side: Remove the bolts and remove the front cover of the underbody, address to Section Removal and installation of the engine compartment lid from the bottom.
6. Driver's side: Remove the screws, remove the bottom of the water tank and take it to one side, refer to Section Removal and installation of the water tank and pump motor.

7. Remove the 2 screws (arrows in the figure) of the headlamp aiming.

8. Remove the headlight (1).


Setting

PERFORMANCE ORDER

1. Insert the fog lamp so that the guide pins included in the bumper.
2. Secure the fog lamp with two screws.
3. Driver's side: Replace the windshield washer reservoir, refer to Section Removal and installation of the water tank and pump motor.
4. Driver's side: Attach the cover underbody.
5. Driver's side: Insert the cartridge with a lamp.
6. Dock connector lights.
7. Install the front locker, address to Section Removal and installation of a forward wing locker.
8. Connect the earth cable (-) battery when the ignition is switched off. Replace the cabin air filter box. If necessary, enter the code for the radio and set the time on the clock.
9. Check the adjustment range headlights and adjust if necessary to the service station.





« previos page
Removing and installing lights
next page »
Removing and installing the lens fog

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.