add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz C-Class (W203, 2000 issue)

general info. full specifications. diagnostics. hints. tips. tricks
Mercedes-Benz W203
Home
 
Mercedes-Benz
W203
Introduction
Instruction Manual
Routine maintenance
Engine
Cooling and heating
The power supply system and release
Electric motor
Manual gearbox
Automatic Transmission
Coupling and power shafts
Brakes
Suspension and steering
Body
Onboard electric
Specifications
Fault diagnosis onboard electric equipment - the general information
Check the wiper motor
Check heated rear window
Relays and fuses
Replacing incandescent exterior lights
Replacing bulbs Interior lighting
Removing and installing daylight sensor
Removing and installing lights
Removing and installing fog
Removing and installing the lens fog
Removing and installing the rear light
Replacing the battery ignition key / remote control
Removing and installing windscreen wiper motor
Removing and installing rear window wiper motor
Removal and installation of the water tank and pump motor
Removal and installation of a rain sensor
Removal and installation of the audio signal
Removing and installing parking sensors
Removing and installing ambient temperature sensor
Removing and installing dashboard
Removal and installation of stalk
Removal and installation of the switch of the front canopy on the ceiling
Removal and installation of the group switches to the left of the control panel
Removing and installing center console switch
Removal and installation of switches in the door
Removal and installation of door switches the interior lighting
Removal and installation of warning signs parking assistant
Removing and installing cigarette lighter
Removal and installation of the radio
Removal and installation of loudspeakers
The digital CAN data bus
The uniform lock - general information
Installation of additional electric and electronic devices
Function and location of electrical connectors
Diagrams
 


Hit Counter by Digits


print page printable version

Removal and installation of stalk



Steering column switch toggles the following instruments: the dipped beam, main beam, direction indicators and windscreen wiper.

Withdrawal

PERFORMANCE ORDER

1. Set the wheels straight.
2. Disconnect the negative (-) cable of the battery when the ignition is off. You must first remove the air filter box of the passenger compartment.

Before disconnecting the cable, find out the radio security code, if any, address to Section Replacement of the battery.

Be sure to follow safety precautions when handling the bag, refer to Section safety instructions for airbag.

3. Remove steering wheel, refer to Section Removal and installation of the steering wheel.

Operation lifting and car installation on supports is connected with danger! Therefore, prior to the operation to check out the Poddomkrachivanie and towing Introduction to management.


4. Remove the bolts (1) contact with the helix facing right front wheels so that you can remove the spiral.

Do not remove the screws completely. Otherwise contact spiral is disassembled it again and have to collect in the middle position (work HUNDRED).

5. Carefully remove the contact spiral stalk. Connector stalk which automatically detach.
6. Remove the 3 screws.

7. Release the stalk connectors (1) by compressing and remove the stalk.


Models Tempostat

PERFORMANCE ORDER

1. Remove the cover under the dashboard, please refer to the appropriate section.
2. Disconnect the plug switch Tempostat (2) of the ignition switch.

3. Remove the stalk switch Tempostat switch, if installed, and remove the plug from the stalk.


Setting

PERFORMANCE ORDER

Be sure to follow safety precautions when handling the bag, refer to Section safety instructions for airbag.

1. Make sure that the wheels of the car are right.
2. Dock Connector stalk and set the switch in place.
3. Insert the 2 connectors in the switch and lock.
4. If there is Tempostat, Dock connector of the ignition switch and replace the cover under the dashboard, please refer to the appropriate section.
5. Fix the steering column switch with three screws.
6. Establish a contact spiral all the way to the steering shaft. Lock connector.

7. Attach the 2 connector. At the same time, take care to coincide both markings (arrows on an illustration).

8. Replace the steering wheel. Please observe the safety precautions when handling the bag, refer to Section safety instructions for airbag.
9. Connect the earth cable (-) battery when the ignition is switched off. Replace the cabin air filter box. If necessary, enter the code for the radio and set the time on the clock.





« previos page
Removing and installing dashboard
next page »
Removal and installation of the switch of the front canopy on the ceiling

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.