REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Sunny (from 1991 to 1997, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Sunny
		Instructions
		Maintenance
		Engines
		Cooling
		Heating and ventilation system
		Fuel and exhaust system
			Carbureted engines
			Engines with fuel injection system
			The power supply / exhaust
				Models with one-point electronic fuel injection
					Specifications
					Air filter
					An accelerator rope
					The accelerator pedal
					Gasoline not containing tetraethyl lead
					Fuel Injection System
					Fuel system
					Fuel pump
					Fuel Level Sensor
					Fuel tank
					Throttle Body
					Fuel injection system / Ignition
					The elements of the fuel injection system
						Fuel injector
						Fuel pressure control
						Additional air valve
						Throttle potentiometer
						Air Flow Sensor
						The solenoid valve of the engine fast
						Temperature Valve rapid engine warming
						Throttle damper
						Sensor crankshaft angle
						Power Transistor
						Coolant temperature
						The gauge of detonation combustion of fuel
						Electronic engine control unit
						Heater fuel mixture
						The switch of neutral transfer
						The switch of blocking of a starter / reversing light
						Relay electronic engine control unit, the heating of the fuel mixture and the fuel pump
						Switch on the system power steering
						Switch the air conditioning system
					Intake manifold
				Models with multi-point electronic fuel injection
			Emission of exhaust gases
		The system of the engine is started
		Coupling
		Transmissions
		Axles
		Brakes
		Suspension and steering
		Body
		Electrical

printable version

Switch on the system power steering

The switch is set in the high-pressure system to strengthen steering in the right rear corner of the engine compartment.

Refitting

PERFORMANCE ORDER

1. Before removing the switch, set the front wheels straight and disconnect the negative battery terminal.

2. Find the switch and unplug the connection socket.

3. Remove the switch, remove the O-ring switch and quickly plug the hole in the tube to prevent leakage of hydraulic fluid and dirt from entering the hydraulic system.

4. Installation is performed in reverse order of removal with a new sealing ring.

« previos page
Relay electronic engine control unit, the heating of the fuel mixture and the fuel pump

next page »
Switch the air conditioning system