REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Sunny (from 1991 to 1997, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Sunny
		Instructions
		Maintenance
		Engines
		Cooling
		Heating and ventilation system
		Fuel and exhaust system
			Carbureted engines
			Engines with fuel injection system
			The power supply / exhaust
				Models with one-point electronic fuel injection
				Models with multi-point electronic fuel injection
					Specifications
					Air filter
					An accelerator rope
					The accelerator pedal
					Fuel Injection System
					Fuel system
					Fuel pump
					Fuel Level Sensor
					Fuel tank
					Throttle Body
					Elements of the fuel injection system (engines of 1.6 liters)
					Elements of the fuel injection system (engines of 2.0 liters)
						The fuel manifold and fuel injectors
						Fuel pressure control
						Throttle potentiometer
						Air Flow Sensor
						Additional air valve
						The solenoid valve of the engine fast
						Adjusting the air supply unit (idle)
						Air intake control valve
						Sensor crankshaft angle
						Power Transistor
						The gauge of detonation combustion of fuel
						The electronic control unit of engine work
						The switch of neutral transfer
						The switch of blocking of a starter / reversing light
						Switch the engine-ECU and fuel pump
						The switch in the steering gain
						Switch the air conditioning system
						Speed sensor
					Intake manifold
			Emission of exhaust gases
		The system of the engine is started
		Coupling
		Transmissions
		Axles
		Brakes
		Suspension and steering
		Body
		Electrical

printable version

The solenoid valve of the engine fast

A warning

The solenoid valve of the engine in the fast idle speed is not sold separately. If it is faulty, replace the entire unit adjusting the air supply when the engine is idling. This unit is attached to the intake manifold, and includes an additional air supply valve, solenoid increasing the engine speed at idle speed adjusting screw and idling.

The solenoid valve of the engine fast idling mounted on the right side of the intake manifold.

Before his removal, disconnect the negative battery terminal.

Refitting

PERFORMANCE ORDER

1. Take a walk along the wires from the solenoid valve to its terminal connections and disconnect the connector connections.

2. Remove the solenoid valve from the intake manifold, remove the plunger and spring-loaded sealing washer.

3. Installation is spent upside-down removals. At installation use a new sealing washer. Make sure the plunger and spring and have been correctly installed.

« previos page
Additional air valve

next page »
Adjusting the air supply unit (idle)