printable version
Disc Rear brakes - check, removal and installation
1. Turn the 2 wheel nuts to hold the disc relative to the flange axis, and check the status of the disc (see. Section 4). 2. Remove the cylinder, loosen the bolts on the flange of the mouth to the rear axle (photo). 3. Remove the disc. If the drive does not give in, then bury penetrating fluid around studs, screw bolts into the holes and wrapping auxiliary bolts, remove the wild (photo). 4. Further operations are performed in reverse order. Tighten the bolts with the specified time
| 8.2 Details Rear disc brakes all-wheel drive and / m Terrano I / Pathfinder "(1988} 1. Cover 2. Bolt finger fitting copper gasket Z. 4. 6. Hose 5.Kryshna Proklatv inner cylinder 7. Cover 8. 9. The cuff of the piston 10. The piston cylinder 11. Cover |
| 8.3 Removing the drive by means of auxiliary bolts 1.Bot M8h125 |
|