add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Terrano II (from 1985 to 1999 model year)

general info. full specifications. diagnostics. hints. tips. tricks
Nissan Terrano 2
Home
 
Nissan
Terrano 2
Operation and Maintenance
Maintenance Vehicle
The four-cylinder engine
Engines VS
All engines
Systems of cooling, heating, ventilation and air conditioning
Fuel and an exhaust system
The system of electric motor
Emission of exhaust gases
Manual transmission
Automatic Transmission
Coupling the propeller shaft and rear axle
Chassis car with wheel formula 4x4
Brakes
Technical data
Overview
Pads disc (front and rear) brakes - replacement
Brake caliper - removal, dismantling and installation
Disc brakes - check, removal and installation
The rear drum brake pads -replacement
The wheel cylinder rear drum brakes - removal, dismantling and installation
See. Ch. 1
Disc Rear brakes - check, removal and installation
Handbrake shoes (disk brakes at the rear) - Removal, installation and adjustment
The main brake cylinder - removal, dismantling and installation
Brake pressure regulator - removal and installation
The line hydraulic drive - check and replacement
Bleeding the brakes
Brake servo - general data and check
Brake servo - removal and installation
Hand brake - adjustment
Handbrake - removal and installation
Brake cable - removal and installation
Brake Light Switch - removal and installation
Anti-lock braking system (ABS) - the general data and access codes.
Suspension and steering
Body and trims
Electrical system
 


Hit Counter by Digits


print page printable version

Overview



Cars equipped with dual-circuit braking system with hydraulic drive, vacuum booster and a pressure regulator
rear brakes (KlSLV - valve). The controller is designed to unlock the rear wheels under heavy braking. Actuated by the pressure difference between the front and rear brake circuits in response to a change in the load on the vehicle.
Front disc brakes, equipped with a two-piston caliper and single-piston sliding.
Rear brake disc or drum. The gaps between the pads and drums are automatically adjusted when the handbrake. The design of the rear disc brake is almost indistinguishable from the design of the front. Hand brake is equipped with cable, it is activated by a lever.




« previos page
Technical data
next page »
Pads disc (front and rear) brakes - replacement

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.