add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Golf IV (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Golf 4
Home
 
Volkswagen
Golf 4
Instructions
Engine
Cooling system
Fuel System
Exhaust system
Ventilation and heating system
Coupling
Transmission
Suspension brackets and power shafts
Steering
Wheels and tires
Brakes
Body
Care body
Care of an upholstery and rugs
Repair of insignificant damages of a body
Repair of strong damages of a body
The front body panel
Removing and installing front bumper
Removing and installing rear bumper
Removal and installation of a forward wing
Removal and installation of facing of a niche of a forward wing
Removal and installation of facing of a niche of the rear wing
Hood
Withdrawal
Setting
Adjusting the hood
Hood lock
Removing and installing radiator grille
Removal and installation of a lateral overlay of a body
Door
Luke
Purification gutter
Mirrors
The center console
Removal and installation of the top furnish in space for feet of the driver
Removal and installation of the glove compartment
Removal and installation of a lateral covering of space for feet
Removal and installation of overlays of thresholds
Removal and installation of the bottom facing of the central rack
Removal and installation of the right lateral covering of a luggage space
Removing and installing luggage compartment floor coverings
Removal and installation of back furnish of a luggage space
Removing and installing front seat
Side airbags
Removing the rear bench seat cushion
Removing and installing rear seat backrest
Washers and wipers
Electrical equipment and wiring
 


Hit Counter by Digits


print page printable version

Hood



Fasteners hood

1 - hood;
2 - buffer;
3 - Front;
4 - insert;
5 - buffer;
6 - the rubber shock absorber;
7 - a guide member;
8 - Seal;
9 - a spring clip;
10 - a hose for the windscreen washer;
11 - seal;
12 - a bolt, 20 Nm;
13 - the hinge;
14 - the hinge housing

PERFORMANCE ORDER
1. Open the hood and enclose pure rags under cowl corners to protect the paintwork when removing the hood of the car.
2. Disconnect the hose from the washer nozzles and electrical connectors.
3. Tie the hose and electrical connector thin long cord.
4. Pull out the hood wiring and hose them untie the cord, leaving him in the hood. In the future, it needs to tighten the cord in the hood wiring and hose.
5. Remove the cover of the hinge (14) of the spring clips right hood hinge.
6. Using a marker, mark the position of the hinges on the hood.
7. Ask the assistant to support the hood in the open position and remove the rack from the hood pneumatic bonnet.
8. For this blade screwdriver pry the spring clip and remove the top part of a rack with a spherical joint on the hood.
9. If you want to remove a pneumatic support of a cowl from the car, in the same way remove the lower part of the support.
10. When removing air support bonnet not completely remove the spring clip from the ball joint, as otherwise the spring bracket is deformed and will have to replace the air support.
11. Remove the bolts left and right hood hinges, and, being careful, remove the hood.
12. Check the condition of the hood hinges on the presence of backlash and wear and, if necessary, replace them.




« previos page
Removal and installation of facing of a niche of the rear wing
next page »
Withdrawal

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.