printable version
Removal and installation of a forward wing
Fasteners front wing
1 - front fender; 2 - bolts of 9 pcs .; 3 - spring clip nuts; | 4 - consolidation; 5 - an arm |
The distance between the top of the front wings and the relative position between the wings in the horizontal and vertical planes
Withdrawal
PERFORMANCE ORDER | 1. Remove the front bumper and the bumper beam. | 2. Remove facing of a niche of a forward wing. | 3. Remove the side repeater turns. | 4. Remove the 9 bolts securing wing (2, see. Fig. Elements of fastening of the front wing). | A warning To avoid damage to paintwork, wrap adhesive tape place in the vicinity of the wing screws.
| 5. The wing is mounted on a protective layer of mastic, so the wing from the body protective soften the mastic with a hair dryer. | 6. hair and put on a flat nozzle, gradually warming up paste, remove the wing. |
|
Setting
PERFORMANCE ORDER | 1. Before installing the wing in place, clean the mating surface and apply a zinc paste in place of attachment of the wing to the wheel housing and the A-pillar. This paste is used as corrosion protection. | 2. Set the front wing on the car, align the bolt holes and tighten the wing bolts. | 3. When installing the wing, make sure that the gaps between the fenders and hood, as well as between the wing and the front door were uniform throughout. | 4. Install the facing of a niche of a forward wing. | 5. Install the bumper beam and the front bumper. |
|
|