 printable version
Toothed belt
Toothed belt motor 1,6- / 1,8-I 1 - a bolt, 45 Nm;
2 - support of the power unit;
3 - a bolt, 25 Nm;
4 - an arm;
5 - the top casing of a gear belt;
6 - middle casing of a gear belt;
7 - a nut, 20 Nm;
8 - a washer;
9 - a tension roller;
10 - a gear belt. Before installation, check the timing belt for wear. Before removing the toothed belt is necessary to note the direction of rotation. It does not bend a gear belt;
11 - a back casing of a gear belt;
12 - O-ring. When you install using the new ring;
13 - the water pump;
14 - a bolt, 15 Nm; | 15 - a pulley of a gear belt of a cranked shaft;
16 - a bolt, 90 Nm, and tighten on a corner 90 ?�. When installing, use a new bolt. Dovorachivanie bolt 90 ?� can be performed in several stages;
17 - the bottom casing of a gear belt;
18 - a bolt, 10 Nm;
19 - pulley pumps';
20 - V-belt. Before removing check the direction of rotation of the belt;
21 - crankshaft pulley. Setting of the pulley is only possible in one position due to the offset mounting bores;
22 - V-belt tensioning mechanism. To loosen the belt tension, using a wrench, take the tension mechanism towards |
The tension of the toothed belt in the four-cylinder petrol engines made roller automatic tensioner that maintains optimal tension of the belt, resulting in longer service life and smooth running toothed belt. | PERFORMANCE ORDER | | 1. Remove the auxiliary V-belt. | | 2. Remove the tension mechanism V auxiliary drive belt. |
|
|
