 printable version
Removal and installation of a flywheel / drive disc
Details of the installation of a flywheel / drive disc  | | |
| - When you release the mounting bolts, lock the flywheel / drive plate from turning by means of a special device (see.
- Removing the flywheel / drive plate, thoroughly clean it, and then check for cracks, burrs, and other mechanical damage, - slight defects can be eliminated by using fine sandpaper, in the case of more serious damage to the assembly should be machined or replaced.
- Assess tooth flywheel / drive disk. If necessary, the ring gear can be replaced by protachivaniya and knocking down a chisel, and the installation of new, - before boarding the flywheel / drive plate new ring gear should be heated to a temperature of 250 ÷ 300 ?� C.
 | The ring gear is set beveled edge to the engine. |
 | - Temporarily secure the flywheel / drive plate to crankshaft and using DTI gauge and determine the value of its cross-beats. If the measured value exceeds 0.2 mm, the flywheel / drive plate should be given to the groove or replace - the maximum depth of the groove is 0.5 mm.
|
|
|
|
