| Home |
| | | Kia |  | Sportage | | Introduction | | Controls and operation receptions | | Current care and maintenance | | Engine | | System of cooling, heating, ventilation and air conditioning | | general information | | Engine cooling system | | | Ventilation systems, heating and air conditioning | | | General information and safety measures | | | Troubleshooting, check the system components K / | | | Removal and installation of assemblage blower / evaporator service components | | | Removal and installation of the heater assembly, maintenance components | | | Removal and installation of communication lines refrigerator path of K / | | | Removal, check and installation of compressor K / V | | | Removal, check and installation of the fan of the condenser K / V | | | Removal, check and installation of the condenser K / V | | |  | Removal, check and installation of the receiver-dryer | | The power supply system, motor control / emission control and exhaust | | Systems of an electric motor | | A five-speed manual gearbox gear | | Automatic Transmission | | Transmission Line | | Brakes | | Suspension and steering | | Body | | Onboard electric | | The control body dimensions | |  | Wiring | | | |
|
|
|
 printable version
Removal and installation of communication lines refrigerator path of K /
| - Support the wheel chock.
- Forces trained professionals make detente a refrigerator path system K / V.
|
|
Line evaporator Withdrawal | - Check the path of the engine cooling components for signs of leaks.
- Disconnect and remove the battery.
- Remove the mounting bolts, wiring and connectors Disconnect the hose connecting the feed pump and remove the tank windscreen washer fluid in the engine compartment (see chap. Body).
- Loosen the flare nuts / bolts on both ends of the line to be lifting.
 | - Remove the nut fastening clamps.
|
 | - Release the line from intermediate clamps and remove it from the vehicle.
|
|
|
Setting |  | - Get a change of line on the regular place and snap it into the interim latches.
|
- Manually capitalize on a couple of threads of the two flare nuts.
- Align the line and tighten the flare nuts to the required torque (13 Nm 32 Nm).
- Screw the socket bolts to the engine compartment bulkhead and tighten them with demanded effort (24 Nm).
- Screw and tighten the retaining nut low.
- Forces trained professionals make evacuation, vacuum check and charging of a refrigerator path system K / V.
- Install and connect the battery.
- Start the engine, activate the K / V connectors and inspect the choke refrigerator path for signs of leaks. If necessary, make appropriate corrections.
|
|
Flexible hoses Withdrawal | - Release nut and remove the compression fittings suitable hose.
|
|
Setting | - Keep a hose on the regular place.
- Screw the flare nuts and tighten them with demanded effort (depending on the connection point).
- Forces trained professionals make evacuation, vacuum check and charging of a refrigerator path system K / V.
- Start the engine, activate the K / V connectors and inspect the choke refrigerator path for signs of leaks. If necessary, make appropriate corrections.
|
|
|
|
