REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Sportage (1999 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Sportage
		Introduction
		Controls and operation receptions
		Current care and maintenance
		Engine
		System of cooling, heating, ventilation and air conditioning
			general information
			Engine cooling system
			Ventilation systems, heating and air conditioning
				General information and safety measures
				Troubleshooting, check the system components K /
				Removal and installation of assemblage blower / evaporator service components
				Removal and installation of the heater assembly, maintenance components
				Removal and installation of communication lines refrigerator path of K /
				Removal, check and installation of compressor K / V
				Removal, check and installation of the fan of the condenser K / V
				Removal, check and installation of the condenser K / V
				Removal, check and installation of the receiver-dryer
		The power supply system, motor control / emission control and exhaust
		Systems of an electric motor
		A five-speed manual gearbox gear
		Automatic Transmission
		Transmission Line
		Brakes
		Suspension and steering
		Body
		Onboard electric
		The control body dimensions
		Wiring

Removal, check and installation of the fan of the condenser K / V

Withdrawal

PERFORMANCE ORDER

The fan assembly is placed in front of the condenser coils, just behind the front grille.
Support the wheel chock.
Disconnect the negative wire from the battery.
Remove the three locking fastening paneling to the upper section of the front cover.
Remove the screw that secures the front grille to the front of the hood.
Gently press the four retaining tab and remove the front grille.
Release the latches of the side sections of the front casing and snap them into their regular places in the front grille.

Check

PERFORMANCE ORDER

Using an ohmmeter make sure available conductivity between the terminal wiring connector fan. If conductivity is absent, replace the drive motor.
Apply to electric power terminals 12 - if the impeller starts to rotate, replace the motor.

Setting

PERFORMANCE ORDER

Installation is the reverse order of disassembly of components - Ensure compliance with the Specification Systems of cooling, heating, ventilation and air conditioning systems to the efforts of a tightening of threaded fasteners and reliability it snaps into place.