REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Sportage (1999 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Sportage
		Introduction
		Controls and operation receptions
		Current care and maintenance
		Engine
		System of cooling, heating, ventilation and air conditioning
		The power supply system, motor control / emission control and exhaust
			Safety and general rules adopted in the service component of fuel paths of internal combustion engines
			The power supply system of petrol engines
				general information
				Checking and adjustment of the idle speed / ignition timing / CO
				Dropping the pressure in the fuel system of a gasoline engine, the fuel filling path
				Power supply system check
				Removal and installation of components of an inlet air path
				Removal and installation of the gas pedal, adjusting the throttle cable
				Removing and installing fuel tank
				Removal and installation of the fuel pump
				Removal and installation of the gauge of a stock of fuel
				Removal and installation of shut-off valve
				Removal and installation of the supply and return lines of a fuel path
				Removing and installing fuel filler and fuel vapor separator
				Removing and installing the fine filter fuel path
				Removal and installation of the fuel pressure regulator
				Removal and installation of the injection line
				Removing and installing the fuel injectors
			The power supply system of diesel engines
			Engine management and emission control
			Exhaust
		Systems of an electric motor
		A five-speed manual gearbox gear
		Automatic Transmission
		Transmission Line
		Brakes
		Suspension and steering
		Body
		Onboard electric
		The control body dimensions
		Wiring

Removal and installation of the gas pedal, adjusting the throttle cable

Pedal

Details of installation of the gas pedal


1 - the throttle cable 2 - Support bracket	3 - Lock 4 - Pedal 5 - Return spring

PERFORMANCE ORDER

Cable

PERFORMANCE ORDER

Make sure in the fullness of closing the throttle.
Measure the freewheel drive cable. If the result is outside the permitted range (1.0 ÷ 3.0 mm), make an appropriate adjustment by turning the adjusting nut (see.