REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Sportage (1999 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Sportage
		Introduction
		Controls and operation receptions
		Current care and maintenance
		Engine
		System of cooling, heating, ventilation and air conditioning
		The power supply system, motor control / emission control and exhaust
			Safety and general rules adopted in the service component of fuel paths of internal combustion engines
			The power supply system of petrol engines
				general information
				Checking and adjustment of the idle speed / ignition timing / CO
				Dropping the pressure in the fuel system of a gasoline engine, the fuel filling path
				Power supply system check
				Removal and installation of components of an inlet air path
				Removal and installation of the gas pedal, adjusting the throttle cable
				Removing and installing fuel tank
				Removal and installation of the fuel pump
				Removal and installation of the gauge of a stock of fuel
				Removal and installation of shut-off valve
				Removal and installation of the supply and return lines of a fuel path
				Removing and installing fuel filler and fuel vapor separator
				Removing and installing the fine filter fuel path
				Removal and installation of the fuel pressure regulator
				Removal and installation of the injection line
				Removing and installing the fuel injectors
			The power supply system of diesel engines
			Engine management and emission control
			Exhaust
		Systems of an electric motor
		A five-speed manual gearbox gear
		Automatic Transmission
		Transmission Line
		Brakes
		Suspension and steering
		Body
		Onboard electric
		The control body dimensions
		Wiring

Removing and installing fuel filler and fuel vapor separator

See. The warning at the beginning of Section Removal and installation of the fuel pump!

PERFORMANCE ORDER

Pull the lever (1) to the left of the center console in front of the driver's seat of the car, release the latch lock hatch access to the fuel filler.

Turning counter-clockwise, remove the oil filler cap.
Remove the three screws that secure the top filler.
Post the car off the ground.
Give a nut of fastening of the support bracket of the front of the neck
Remove the two screws securing the support bracket filler to the frame of the car.
Remove the mounting bolt to the filler neck of the fuel vapor separator.
Release clamps turns of fuel vapor separator to the gas tank nipples.

Remove the fuel vapor separator.
Details of installation of the filler neck (1) of the fuel tank and fuel vapor separator (2)

Release a fixing collar and separate the filler neck on the connecting pipe to the tank.
Installation is in the reverse order - track correctness of connecting the evaporator lines and reliability of fixing of the respective hoses and mounting clamps.