add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 323 (1985 release)

general info. full specifications. diagnostics. hints. tips. tricks
Mazda 323
Home
 
Mazda
323
Introduction
Gasoline engines
Engine oil
Engine cooling system
Ignition system
The power supply system, the carburettor, fuel injection system
Diesel engine
Exhaust
Coupling
Manual gearbox
Automatic Transmission
Suspension and steering system
Brakes
Wheels and tires, a body, car coloring, care of the car
Electrical system
Heater, illumination system, devices
Heater
Fan Motor
Removal and installation of the heater fan
Heater controls
Adjusting drive heater
Check the fan motor / predrezistorov
Check the heater switch
Lighting system
Table lamps
Replacement of lamps of external lighting
Spotlight
Removing and installing lights
Adjustment of headlights
Removing and installing rear lights
Devices
Dashboard
Removal and installation of the instrument panel
Devices
Removal and installation of the radio
Removal and installation of loudspeakers
Removal and installation of the antenna whip
Replacing the wiper blades
Removing and installing / adjusting washer nozzles
Removal and installation of front wiper arm
Front wiper
Removing and installing front windscreen wiper motor
Rear Wiper
Removing and installing rear window wiper motor
Removing and installing rear window wiper arm
Controls and operation receptions
Electrical diagrams
 


Hit Counter by Digits


print page printable version

Lighting system



The lighting system consists of: the main headlights, taillights, brake lights, rear lights, license plate illumination lights, direction indicators, rear fog lights, interior lighting. Lighting devices will be discussed in Section devices.

Incandescent lamps are subject to wear. They should be replaced every 2 years, even if they are still intact. This does not apply to lamps H4 (galogennnye lamp) main headlights, they persist for much longer and can only be replaced in case of failure. Lamp with weakened brightness detected by the black fly on a glass flask. Before replacing the lamp, turn off the switch of the corresponding user.

Do not reach for the glass bulb with your fingers. Fingerprints obscure the lamp and due to the heat reflector give the cake. Be sure to use the lamp of the same performance. If you have stains on the glass bulb to remove them with a cloth and alcohol.





« previos page
Check the heater switch
next page »
Table lamps

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.