REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 323 (1985 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	323
		Introduction
		Gasoline engines
		Engine oil
		Engine cooling system
		Ignition system
		The power supply system, the carburettor, fuel injection system
		Diesel engine
		Exhaust
		Coupling
		Manual gearbox
		Automatic Transmission
		Suspension and steering system
		Brakes
		Wheels and tires, a body, car coloring, care of the car
		Electrical system
		Heater, illumination system, devices
			Heater
			Fan Motor
			Removal and installation of the heater fan
			Heater controls
			Adjusting drive heater
			Check the fan motor / predrezistorov
			Check the heater switch
			Lighting system
			Table lamps
			Replacement of lamps of external lighting
			Spotlight
			Removing and installing lights
			Adjustment of headlights
			Removing and installing rear lights
			Devices
			Dashboard
			Removal and installation of the instrument panel
			Devices
			Removal and installation of the radio
			Removal and installation of loudspeakers
			Removal and installation of the antenna whip
			Replacing the wiper blades
			Removing and installing / adjusting washer nozzles
			Removal and installation of front wiper arm
			Front wiper
			Removing and installing front windscreen wiper motor
			Rear Wiper
			Removing and installing rear window wiper motor
			Removing and installing rear window wiper arm
		Controls and operation receptions
		Electrical diagrams

Devices

Hatchback with 10/89 Vol.


1 - Printed Circuit Board 2 - a control lamp with a cartridge 3 - the case of the instrument panel 4 - hours 5 - coolant temperature and fuel supply	6 - speedometer 7 - tach 8 - housing cover of the instrument panel

Sedan / CD with 10/89 Vol.


1 - a control lamp with a cartridge 2 - The housing 3 - coolant temperature 4 - Cover the body of the instrument panel	5 - tachometer 6 - speedometer 7 --reserve fuel

9/85 - 9/89 MY.


1 - Bolts 2 - a cover of the housing of the instrument panel 3 - coolant temperature and fuel supply 4 - a speedometer	5 - pad signal lights 6 - board 7 - housing units 8 - a printed circuit board

PERFORMANCE ORDER

Screw the tachometer shaft to the gearbox. Get the shaft so that it has not been bent. Insert the rubber seal in the guide bushing engine compartment bulkhead.
Insert and screw the visor.
If removed, install the switch on the steering column. Ensure that the arm turn signals in the middle position, otherwise it may be damaged by the cam returns.
Refit the steering column.
Install the steering wheel, see. Chapter suspension and steering system, Section Removal and installation of the steering wheel.
Connect the battery earth cable.
If available, set the clock and set the security code radio.