|
|
 printable version
Replacement of lamps of external lighting
 | Turn off the appropriate lamp. |
Headlights
| - Open the hood.
 | - Disconnect the plug.
|
 | - Remove the cover.
|
- Disconnect the wire bracket lamps on the retainer and folded back.
- Remove the defective lamp.
- Insert new lamp so that the projections fit into the corresponding recess on the housing. At the same time hold the lamp by the chuck, not the bottle.
- Fold back the spring clip forwards and engage the lock.
 | - Set the cover on the back of the lamp so that the designation "TOP" was drawn up.
|
- Connect to the cartridge connector.
- Check the headlights adjusted in a workshop.
|
|
The front blinkers |  | - Cars up to 9/89 MY .: unscrew the glass skylight. Slightly to press the bulb into the socket, turn it 90 ?� to the left and remove.
|
- Check the gasket glass for damage and replace if necessary.
- Insert the new lamp, slightly to press and turn right. Insert and screw the glass skylight.
 | - Cars since 10/89 MY .: unscrew the glass skylight. Slightly to press -2- lamp holder, rotated 90 ?� to the left and remove.
|
- Check the gasket glass for damage and replace if necessary.
- Insert the new lamp, slightly to press and turn right. Insert and screw the glass skylight.
|
|
Front parking light | - Cars up to 9/89 MY .: unscrew bolts on the glass lantern.
- Remove the old lamp from the socket -3, it just stuck.
 | - Insert and gently push the new lamp.
|
- Screw the glass skylight. Cracked or damaged gasket replaced.
- Cars since 10/89 MY .: unscrew the glass skylight. Remove the old lamp from the socket -1, it just stuck
- Insert and gently push the new lamp.
- Screw the glass skylight. Cracked or damaged gasket replaced.
|
|
Rear lights |  | - Cars up to 9/89 MY .: Remove the cover lanterns in the trunk. Pre pull pin lock with a small screwdriver and remove the lock.
|
- Release clips -arrows- and remove the bulb holder. Faulty lamp slightly to press into the socket, turn it 90 ?� to the left and remove.
- Insert the new lamp, slightly to press and turn right. Insert the bulb holder, push and snap.
 | - Sedan from 10/89 MY .: Loosen and remove the bulb holder. Faulty lamp slightly to press into the socket, turn to the left and take out 90. On models CD release cover the corresponding lamp in the trunk. Turn the bulb holder to the left and remove.
|
- Insert the new lamp, slightly to press and turn right. Sedan insert the bulb holder, press and snap. CD: Insert the cartridge and secure by turning to the right. Attach the cover.
- Versatile: Open a back door. Unscrew the torch and swivel to the side.
- Turn the corresponding bulb holder to the left and remove.
 | - Slightly to press the old bulb into the socket, turn 90 ?� to the left and remove.
|
- Insert the new lamp, slightly to press and turn right.
- Pre replace cracked gasket.
- Insert the cartridge and lock by turning to the right.
- Install the lamp and screw it. Close the door tailgate.
|
|
Rear fog lights |  | - Cars since 10/89 MY: Slightly to press an old lamp in the socket, rotate 90 ?� to the left and remove it.
|
- Insert the new lamp, slightly to press and turn right.
- Or damaged or cracked gasket replaced.
- Insert the cartridge and lock by turning to the right.
- On MAZDA CD to install the cover.
|
|
Side blinkers | - Unscrew the glass lamp (2 screws). Remove the bulb from the socket, insert new bulb, screw the glass.
|
|
Number plate lights |  | - Cars up to 9/89 MY .: Remove the light cover by placing something under a screwdriver to scratch the surface.
|
- Remove the bulb holder.
- Remove the bulb from the socket. Insert the new lamp.
- Insert the cartridge.
- Push and snap the lamp housing.
 | - Cars since 10/89 MY .: unscrew the lamp and remove it. Remove glass with gasket.
|
- Slightly to press a faulty lamp in the socket, rotate 90 ?� to the left and remove it.
- Insert the new lamp, slightly to press and turn it to the right. Insert the bulb holder, put on the gasket and glass, screw the lantern.
|
|
Changing bulbs in the retractable headlights
|
|
