|
|
 printable version
Removing and installing front windscreen wiper motor
Withdrawal | - Disconnect earth cable from the battery.
 | This data is erased from the memory of malfunctions of the engine or a protective code of a radio receiver. Before disconnecting the battery should read instructions in Section Removal and installation of the battery. |
 | - Turn off the motor of the multi-plug.
|
- Unscrew the motor body from the plate (2 screws).
- Squeeze from the crank rod -6- -5- large screwdriver.
| If you want to remove from the engine crank previously should mark its position relative to the holder (label). |
|
|
Setting | - When installing a new motor steklochistitelya it must first be brought into its final position. To do this, connect the plug and allow the motor to work for about 1 minute. Then, turn off the engine and switch to be established in its final position. Disconnect the plug.
- Screw the crank on the motor according to the labeling on the adapter and tighten with torque of 15 Nm.
- Fit the crank rod and screw the motor torque of 10 Nm.
- Connect the multi-connector.
- Connect the earth cable to the battery.
- Check the operation of the wiper.
- If available, set the clock and set the security code radio.
|
|
|
|
