|
|
 printable version
Removing and installing rear window wiper motor
Withdrawal | - Disconnect earth cable from the battery.
 | This data is erased from the memory of malfunctions of the engine or a protective code of a radio receiver. Before disconnecting the battery should read instructions in Section Removal and installation of the battery. |
- Remove the bottom upholstery of a back door.
- Remove the wiper arm.
- Remove the sealing cap, unscrew and remove the outer sleeve.
- Turn off the motor of the multi-plug.
- Unscrew the motor from the body, for this to turn out 4 bolts.
|
|
Setting | - When installing a new motor steklochistitelya it must first be brought into its final position. To do this, connect the plug and allow the motor to work for about 1 minute. Then, turn off the engine and switch to be established in its final position. Disconnect the plug.
- Screw the motor to the door of a back with a force of 10 Nm.
- Install the outer sleeve, tighten the nut to 5 Nm.
- Push the sealing cap.
- Install the wiper arm.
- Connect to the motor connector.
- Connect the earth cable to the battery.
- Check the operation of the wiper.
- If available, set the clock and set the security code radio.
- Set the bottom upholstery of a back door.
|
|
|
|
