printable version
The handle of the front door
| 1. Door Handle 2. Guide the lock cylinder 3. Swivel rod 4. Gasket 5. Laying | 6. Bolt with hexagon socket 4 mm 7. The retaining bracket bolt 8. Support bracket 9. Screws |
Withdrawal PERFORMANCE ORDER | 1. Remove the door seal at the height of the door lock slot door. | 2. Unscrew about 4 turns the Allen bolt (6) with a 4 mm Allen key through the hole in the door. Bolt with hexagon socket is secured against falling out holder (7). | 3. Guide (2), first pull back, and then out. | 4. Pull the door handle (1) with the gasket (4) of the back support bracket and remove. The support bracket can be, if necessary, removed from the inside of the door, but it does remove the door trim. | 5. Remove the gasket (5). |
|
Setting Door lock | 2 - directing the lock cylinder 3 - pivot shaft 10 - the eccentric adjuster screw 11 - Door Lock 12 - control lever |
| 11 - Door Lock 13 - hole for eccentric adjustment screw 14 - hole for the Allen screw |
PERFORMANCE ORDER | 1. Install an eccentric adjustment screw (10) to the outside, so that the door handle is mounted easily. | 2. Install the door handle with a lining and thus enter into a control lever (12) of the door lock. | 3. Insert the rear rail of the lock cylinder (2) and also enter the rotary rod (3) in the control door lock. | 4. Secure the door lock bolt with hexagon socket. | 5. Adjust via an eccentric bolt (10), the clearance between the handle (1) and the control lever (12) with a Phillips screwdriver through the hole (13) on the front side of the door. The gap should be from 1 to 3 mm. | 6. Insert the door seal and check door operation. |
|
|