 printable version
Spotlight
| 14. plugs to indicator lamp
30. plugs to light
32. A hose to a device for cleaning the lens of lamp (headlamp cleaning system and headlight wipers)
| 33. The pneumatic tubing
M6 / 2x1, M6 / 3x1. Plug wiper motor to the left / right |
| 22. Nut 23 Washer
24. Cervical wiper arm
25. Protective cover
26-29. Screws
34. Bolt | E1, E2. Lights left / right
M6 / 2, M6 / 3. Wiper Motor Headlight left / right
M6 / 2x1, M6 / 3x1. Plug wiper motor to the left / right |
Withdrawal | PERFORMANCE ORDER | | 1. Remove the turn signal lamp. | | 2. Remove the headlight electrical wires and air line to adjust the height. | | 3. If present, remove the wiper arm (24) lights. To do this, fold up the protective cover, unscrew the nut (22) and remove it along with the washer (23). | | 4. Depending on the equipment, remove the crossmember and side guards in the area of fastening lights. | | 5. Remove the two screws (26) and unhook the protection cover (25) under the spotlight. | | 6. Remove the screws (27-29) and gently pull the headlight forward. Close the damper with a cloth to avoid scratching it. | | 7. If there is, remove the hose to the device for cleaning the lens of lamp. | | 8. If you must remove the lens optical element lights, remove the rubber seal. Remove the spring clip at the top and bottom of the two support rings (38). Remove the lens of the optical element (9) with the seal (21). |
|
Setting | PERFORMANCE ORDER | | 1. If removed, insert the lens of the optical element and the headlamp housing at the same time it is pressed as long as the supporting earrings top and bottom snaps into place. | | 2. In advance, check the seal on the absence of porosity, if necessary, replace it. | | 3. The further installation is made in sequence, return dismantling. | | 4. After assembly, adjust the lights in a specialized repair shop. |
|
|
