Start the engine from the external power supply. Mercedes-Benz E-Class

REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz E-Class

general info. full specifications. diagnostics. hints. tips. tricks

To connect charged and discharged battery, use the special cable. In this case, the electronic devices of the car will be protected from dangerous power surges.

To start up the engine of the car with the discharged battery using an auxiliary battery, not necessarily connected to the terminals of the starter auxiliary battery - engine compartment Mercedes E-Class make it much easier

Fig. 9.9. To start up the engine of the car with the discharged battery using an auxiliary battery, not necessarily connected to the terminals of the starter auxiliary battery - engine compartment Mercedes E-Class make it much easier

SEQUENCE OF WORK

1. Vehicle, which is Implemented vlyatsya engine starting, position such that the battery contacts the two vehicles could be connected by wires.

2. Turn off the car all consumers of energy.

3. Connect the positive battery terminal first fixing terminal wire to a discharged battery, then charged.

4. The second wire first connect to the negative terminal of the car with a charged battery, then to the negative terminal of discharged battery.

5. Start up the engine in a car with a charged battery and keep working at high speeds, in order to provide sufficient voltage generator.

6. Start the engine of your car. If the engine does not start immediately, between attempts to be paused, allowing the starter to cool. The engine of the first car to keep working: flat battery is getting recharged.

7. Remove the wires in the following order: first to the negative terminal batarei- "donor" and then with his own. Remove the wire from the positive terminal first with a car with a charged battery, then discharged.

8. After starting the engine for a while let it run at high speeds, the generator can recharge the battery.

PRACTICAL ADVICE

Start the motor vehicle towing

This method is not suitable for a car with a faulty ignition system. Work should be an experienced assistant. Remember that when the engine is not running the brake booster.

1. Turn on the ignition and 2nd gear and press the clutch pedal.

2. The towing vehicle has to move slowly.

3. At a speed of about 15 km / h, slowly release the clutch pedal. Be ready to brake (right foot on the brake pedal).

4. If the engine is empty, press the clutch pedal, then accelerator pedal.

5. beeps the driver of the towing vehicle and a soft stop both cars.

Start the engine by pushing

This method is preferred if the engine and starter motor are in good condition. It is pushing to abandon if the engine does not start due to a failure in the ignition system not burnt remains of the fuel mixture can ignite and damage the catalytic converter.

1. Turn on the ignition and 1st gear. In higher gears generator will rotate fast enough to provide a high voltage.

2. Press the clutch pedal, start to push the car until it roll.

3. Quickly release the clutch pedal - the engine crankshaft provernetsya, the engine must be started up. When he started, quickly press the clutch pedal, then accelerator pedal.