printable version
Control equipment
The driver must constantly monitor the technical condition of the vehicle and to control the situation on the road. For this are control devices. They are a combination of devices, consisting of three well-readable round instruments that inform about the frequency of engine speed, vehicle speed, coolant temperature and fuel level, as well as pointers ambient temperature, general and daily run, hours that are built into basic round instruments as LCDs. For further information the driver receives in the event of any failure: illuminate various indicator and warning lights that are not normally visible. The E-Class most of the parameters controlled by electronic devices. The driver can only follow the testimony of a small number of indicators and warning lights. Lamp oil pressure control airbag Lamp oil pressure or control airbag should light up only when the ignition is switched on for about 6 seconds. If, on the other hand, the lamp does not go off, lights or flashes during the trip, in the airbag appeared fault. In this case, you should immediately check in the workshop. Sensors, wires and switches In the control systems as failures occur. Sometimes, due to damage to sensors or wiring faulty switch causes the incorrect information. If you have found that many devices show corrupted data may be a problem with the voltage regulator of the generator, so the system voltage is increased or decreased.
|