 printable version
Check and adjustment of level / replacement of oil builds bridges
 | Check and replacement must be carried out at the heated axle gear. |
Front axle  | Location filler plugs / control (1) and the drain (2) holes of the front axle housing |
Check | - Carefully wipe the surface of the axle around the filler / control (1) opening.
- Remove the oil - oil level must reach the lower edge of the hole, if necessary, make appropriate adjustment (use a funnel). Make sure that the plug has been tightened with demanded effort.
|
|
Replacement | - Prepare a drain container suitable volume.
- Rubbing the surface of the casing around the two holes, remove the filler (1) and the drain (2) plugs.
- Wait until the oil leakage, then screw into place and tighten with demanded effort drain plug (2) - if necessary, replace the pre-washer.
- Pour through a funnel into the gear unit the necessary quantity of fresh oil grades required, - the oil level should reach the lower edge of the fill / check hole.
- Screw and tighten with demanded effort plug (1).
|
|
Rear Axle  | Location filler plugs / control (1) and the drain (2) holes rear axle housing |
The procedure is similar to the procedures described above for the front axle. | In order to ensure proper access to the filler / level plug the car should be lowered to the wheels. |
|
