add to favorites contacts sitemap
Nissan Primera (from 1990 to 1992, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Nissan Primera
Routine maintenance and servicing
The routine maintenance schedule
Current Care
General information on setting up
Check of levels of liquids
Checking the status of the tire and the pressure therein
Replacing the motor oil and oil filter
Check the fluid level of steering hydrostrengthening
Checking automatic transmission fluid
The rotation of the wheels
Check and replacement of hoses of the engine compartment
Check the status, tension adjustment and replacement of belts
Check and adjust the idle speed of the engine and the level of CO
Checking the status of the battery, care it and gymnastics
Check and replacement of spark plugs
Check and replacement candle explosive wires, distributor cap and slider
Checking the oil level in manual gearbox
Check and adjustment of backlashes of valves
Checking and lubricating the throttle actuator rod
Replacing the air filter
Check the fuel system
Check the functioning of the cooling system
Checking the exhaust system
Checking the suspension components and steering
Check condition of protective covers of power shafts
Check the brake system
Check and replace wiper blades
Transmission Fluid Replacement
Drain, rinse and refill the cooling system
Replacement of the fuel filter
Changing gear oil manual transmission
Cooling and heating
The power supply system and exhaust
Electrical system motor
Manual transmission, differential and the main transfer
Automatic Transmission
Coupling and power shafts
Suspension and steering
Onboard electric

Hit Counter by Digits

print page printable version

The rotation of the wheels

Twice a year or every 10,000 kilometers (whichever comes first)

Rotation can be done either through specified in the schedule of routine maintenance intervals or when signs of uneven tread wear. However, remember that in case of successful rotation of all four wheels you eventually have to replace all the tires at the same time. Since this procedure requires raising the vehicle off the ground and remove the wheels, at the same time check the brake operation (see. Section Checking braking system).

Even if you are not going to make the rotation, at least check the tightness of the wheel bolts.

It is recommended to rotate under the special scheme, so that the direction of their rotation was not changed.

Driving the rotation of the wheels.


  1. Refer to information in Section Poddomkrachivanie and towing for the proper raising of the car and change the wheel.
  2. The car should raise winch or install it on a support to all four wheels raised off the ground. Make sure that the vehicle is properly secured!
  3. After the procedure of rotation check and adjust the tire pressure, and do not forget to check the tightness of the wheel bolts.

« previos page
Checking automatic transmission fluid
next page »
Check and replacement of hoses of the engine compartment

Copyright © 2010 Trademarks belong to their respective owners. All rights reserved.