1. Check the gap between the pads and the disc (drum) by repeatedly pressing the pedal. |
2. Raise the rear of the vehicle and remove the wheels. |
3. If the rear brake disc, make sure that when you release the brake pedal and the lever arm rests against the slide stop. |
4. Remove the center section of the front panel. |
5. Determine the number of clicks of the lever until resistance is felt. |
| 6. Turn the nut to adjust the stroke of the lever (see. Subsection 11.1). |
7. Make sure that when the rear wheel brakes locked and when you turn off freely. |
8. Check fire of a control lamp after applying the brake. If necessary, adjust the switch (see. Subpart 11.18). |
9. Install the front section and lower the car. |
10. Before departure check up work of a manual brake. |