1. If liquid different from the recommended system should be flushed and replace all seals. |
2. Before removing the air should eliminate any infringement of tightness of the hydraulic drive. |
3. Put the vehicle on a level surface, stop the engine and turn on the handbrake. |
4. Remove the cap and wipe clean all fitting. |
5. Remove the lid, add fluid to the MAX. |
6. Loosely screw the lid, taking into account that the liquid level must always be kept above the mark MIN. |
7. In the absence of a specific set of works on removal of air should be carried out together. |
8. When using a special set of guidelines instructions supplied with the kit. |
9. Regardless of how you should observe the sequence of pumping. |
10. If the hydraulic partially depressurized, we can restrict venting only depressurize the circuit. |
11. The sequence of pumping brakes rear left, front right, rear right, front left. |
12. Prepare a glass container and a hose. |
| |
13. Put the hose to the fitting (left arrow Set the cap fitting). |
14. The other end place in a vessel by pouring some liquid. |
15. Check the fluid level in the reservoir. |
16. Have an assistant several times to press the brake pedal and hold. |
17. Remove the nipple 1 turn. When the liquid ceases to flow wrap socket and ask the assistant to release the pedal. |
18. Check the fluid level in the reservoir. |
19. Repeat this cycle until the air has been removed from the system, as evidenced by the absence of bubbles in the fluid flowing through the hose. Between the individual cycles held for about 5 seconds. |
20. Install the dust cap, tighten the fitting, remove the hose and put the cap. |
21. Repeat the procedure on the other wheels. |
22. Check the fluid level in the reservoir. |
23. After pumping the brake pedal should be "stiff". |
24. Otherwise, repeat the procedure. |
25. If after repeating the pumping pedal remains "soft", the reason is the wear sleeves cylinders. |