printable version
Brake cable
Rope of rear brake
There are 2 cable - the left and right.
Withdrawal
PERFORMANCE ORDER | 1. Lift the front of the car and establish on supports. | 2. Release the handbrake. | | 3. On the rear drum brakes, remove the pad and disconnect the cable from the lever, remove the spring and the cable bracket (arrows indicate the brake bracket nuts). | | 4. On the rear disc brakes, remove the bracket. | | 5. Remove the end of the cable (arrow) from the lever at the rear brake caliper. | 6. Remove the nuts and bolts attaching the brackets to the bottom of the sheath. | 7. Disconnect the cable from the leveling roller in front of the car and remove the cable. | 8. To access the roller is required to remove the heat shield. |
|
Setting
PERFORMANCE ORDER | 1. The cable is installed in reverse order. | 2. The protrusion on the arm of a cable must go into a recess in the caliper (disc brakes). | 3. Adjust the cable. |
|
CABLES front brakes
Withdrawal
PERFORMANCE ORDER | 1. Disconnect the battery from weight. | 2. Lock the rear wheel and release the parking brake. | 3. Remove the center section of the front panel. | 4. Remove the socket from the switch of a control lamp of a manual brake. | 5. Count the number of threads to the nut, remove the nut and remove the adjusting screw on the brake lever. | 6. Lift the front of the vehicle. | 7. Disconnect the cables from the rear equalizing roller in front of the car and remove the cable. | 8. Remove the cables from the front equalizer and the adjustment bolt, passing through a hole in the floor. |
|
Setting
PERFORMANCE ORDER | 1. The cable is installed in reverse order. | 2. Remove the nut on the pre-counted the number of threads, test the brakes and adjust if necessary. | 3. Before installing the panel, check the power switch and control lamp. |
|
|