1. Lift the front of the car and establish on supports. |
2. Remove the front wheels. |
3. Pull the caliper, the piston entered the cylinder, making sure the liquid level in the tank. |
| 4. If necessary, press the piston by means of a clamp. |
| 5. Remove the caliper fingers (Stelka). |
| 6. Remove the caliper from the disc. |
7. Keep in mind that the outer strip can remain on the bracket. |
8. After removal of the caliper on the brake pedal is not pressed. |
| 9. Fix the caliper so that it does not hang on the hose. |
| 10. Remove shims. |
| 11. Remove the pads. |
| 12. Remove the pad retainers. |
13. Check the thickness of the friction linings. |
14. If the thickness is at least one less than normal lining or pads are very dirty, replace all the pads in the kit on the same axle. |
15. Find and eliminate the cause of contamination. |
16. Do not rearrange the blocks to compensate for wear. |
17. If the condition is satisfactory pad, then clean them by removing grime and large particles. |
18. Clean the contact surface and pads in the caliper bracket. |
19. Before assembly, check the freedom of movement of fingers in the bracket and caliper as well as the integrity of the rubber covers. |
20. Check the seals of the piston, the piston corrosion and traces of leakage. |
21. If the pads will vary, it should displace the piston to provide a place for shoes. |
22. By moving the piston watch liquid level, excess fluid should be removed, or a rubber bulb syringe. |
23. Lightly grease the plate pads, gaskets and spring clips antinoise special grease. |
24. Install the brackets, pads and pads in the caliper bracket. The outer strip is installed in the bracket and the inside - in the caliper. |
25. Make sure that the latch inner pads came into engagement with the piston. |
26. Establish a support, lubricate your fingers slide fixing structure and tighten. |
27. Tighten your fingers with the set moment. |
28. Check the freedom of movement of the caliper on the fingers. |
29. Repeat these steps for the other wheel brake. |
30. Tap a few times on the brake pedal. |
31. Establish wheels, lower the car. |
32. Check the fluid level. |
33. Before leaving, check the brakes. |