REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Sunny (from 1991 to 1997, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Sunny
		Instructions
		Maintenance
		Engines
		Cooling
		Heating and ventilation system
		Fuel and exhaust system
		The system of the engine is started
		Coupling
		Transmissions
		Axles
		Brakes
		Suspension and steering
			Technical data
			Front hub bearing
			Strut front suspension
			The lower arm
			Ball joint lower arm
			Stabilizer bar front suspension
			Bearings rear wheels
			Parts rear suspension
			Steering wheel
			The ignition switch and the lock of blocking of a steering column
			Steering column
			Steering gear
			Covers Steering gear
			Hydraulic
			Power-steering pump
			Ball Joint
		Body
		Electrical

printable version

Hydraulic

Bleed the must in the case of bubbles in the tank while listening to clicks and increased noise during operation of the pump.

With slow turning the steering wheel, or straight-line motion of the hydraulic actuator is accompanied by a hissing sound, the appearance of which is not a basis for pumping hydraulic drive.

Removal of air from hydraulic drive

PERFORMANCE ORDER

1. Lift the front of the car and establish on supports.

2. Check and if necessary restore the level of liquid in a tank.

3. Have an assistant turn the steering wheel in both directions to stop and observe the fluid level.

4. When the level drops, top up.

5. Repeat these steps until the level no longer fall. Otherwise, the system has a leak.

6. Start the engine and repeat the procedure.

7. After the stabilization of lower the car.

« previos page
Covers Steering gear

next page »
Power-steering pump