printable version
Bleeding the brakes
Attention! Before pumping the brakes on the cars equipped with ABS- system, disconnect the battery from weight. Pump the brake is recommended together. |
1. The need for pumping occurs after the replacement of parts of hydraulic drive line. When disassembling a hydraulic drive wheels can only restrict pumping loop parses. 2. Lift the car and establish on supports. Click several times on the brake pedal. Before pumping to restore the level of liquid in a tank during pumping maintain the level, avoiding emptying the tank. 3. Start pumping with pressure regulator. Remove not easy tighten bleed screw (see photo). 4. Connect the hose fitting and the other end into a container with brake fluid. 5. Ask the assistant to press several times on the brakes and hold the sadness. Remove the fitting and after 2 seconds after the stream of flowing liquid with bubbles weaken, tighten fitting. Ask the assistant to release the pedal. 6. Repeat 8-9 times, until in the effluent will not cease to observe the bubbles. Tighten the union. 8. Follow these steps on the brake cylinders in sequence: right rear, left rear, right front, left front. After the reset level in the reservoir.
|