1. Remove the bolt adjusting lath of the generator to a block head. |
2. Remove the top cover 8 (see. Fig. Camshaft drive) Timing. |
3. Remove the cover 5 (see. Fig. The cylinder head) cylinder head and gasket 4. |
4. Remove the inlet pipe and the exhaust manifold. |
5. Rotate the crankshaft so that the piston of the first cylinder was established in TDC compression stroke, with both valves closed. The label on a camshaft cogwheel should coincide with a label on the cylinder head, as shown in Fig. Adjust the belt camshaft drive. Then turn the crankshaft a quarter turn counter-clockwise, so that none of the pistons was not in TDC. |
6. Loosen the belt tension 3. For this Loosen three bolts of 1 fastening of the water pump and turn the pump to the engine block. |
7. Remove the belt from the camshaft gear. |
8. Remove bolts 11 (see. Fig. The cylinder head) cylinder head. Turn away bolts evenly in the reverse order shown in Fig. Tightening bolts of the cylinder head. |
9. Remove the cylinder head. |
10. Remove the gasket 1 (see. Fig. The cylinder head) of the head unit. |
11. After inspection and replacement of damaged and worn parts installation of the cylinder head in the reverse order. Thus it is necessary to replace the cylinder head gasket 1 and the cylinder head cover 5. 1 cylinder head gasket is put on the surface of the cylinder up words ?�OBEN-TOP?�. |
12. Before you put the belt camshaft drive, install the camshaft, and then the crankshaft at TDC. |
13. Tighten the cylinder head in the order shown in Fig. Tightening bolts of the cylinder head in four stages: 1st stage 40 Nm (4.0 kgf-m); 2nd stage 60 Nm (6.0 kgf-m); 3rd stage further tighten a quarter turn (90 ?�); 4th stage further tighten a quarter turn (90 ?�). A warning Tighten head bolts can be only in a cold engine.
|
14. After the installation of the cylinder head to check and, if necessary, to adjust the ignition and the clearances in the valve mechanism. |