A warning  When installing the battery, do not press a hose designed to remove gases released during operation of the battery (see. Fig. Connecting the hose to bring gas from the accumulator formed in his work). The hose has a venting valve, which protects the battery from the back of the flash.
|
| 1. Place the battery on one side of the support bracket (see. Fig. Elements of fastening of the battery). |
 | 2. When installing the battery, make sure that the locking tab (1) at the base of the battery established in the groove of the support bracket (arrow). |
| 3. Since the second hand tighten the battery mounting plate and screw its bolt, having tightened its moment of 20 Nm. |
| 4. Check the battery attachment, as otherwise the battery life can be significantly reduced. |
| 5. Connect the tip of the wire to the positive terminal of the battery and tighten the bolt terminals 6 Nm. Refit the fuse holder on the battery, and the conductive strip should be established to bolt the positive terminal of the battery. |
| 6. Secure the body of the fuse on the housing of the battery. |
| 7. Screw the bolt conductive plate to the positive terminal of the battery. |
| 8. Place the fuse in the fuse holder. |
| 9. Connect the fuse holder to the electrical connector. |
| 10. Connect the ground cable to the battery and tighten the bolts to 6 Nm. |
| 11. If the car is equipped with radio code, re-reprogram it. |
| 12. Set the time on the clock. |
13. Activate the power windows:
- Close the outside of the vehicle through the driver's door or the front passenger door. Make sure the windows and doors are properly closed;
- Re-close the vehicle key, while the hold switch in the closed position for at least 1 sec.
A warning If there is a defect in the power window, the backlight control buttons on the door will flash.
|
