REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Golf IV (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Golf 4
		Instructions
		Engine
		Cooling system
		Fuel System
		Exhaust system
		Ventilation and heating system
		Coupling
		Transmission
		Suspension brackets and power shafts
		Steering
		Wheels and tires
		Brakes
		Body
		Electrical equipment and wiring
			Incandescent lamps
			Electrical circuits
			Detection of open circuit
			Circuit breakers
			Battery
			Generator
			Starter
				The engine starting system
				Refitting
				Check, removal and installation of the traction relay of a starter
				The basic malfunctions of a starter
			Replacement of bulbs of external illumination
			Removing and installing additional brake light
			Replacement of bulbs of internal illumination
			Devices of external illumination
			Adjusting headlights
			Removal and installation of the instrument cluster
			Removing and installing steering column switch
			Removal and installation of switches
			Removal and installation of the radio
			Removal and installation of tweeters
			Removal and installation of low-frequency speakers
			Recommendations for telephone installation
			Antenna
			Check the rear window defogger
			Understanding the electrical circuits
			Diagrams of car VW Golf since September, 1997

Refitting

Withdrawal

PERFORMANCE ORDER

1. Turn off the ignition and remove a wire of weight from the accumulator.
2. Tighten a manual brake, then lift the front of the car and fix on supports.
3. Remove the bottom mudguard of a motor compartment.
	4. Remove the bracket (1) supporting the coolant tube. Unscrew the nuts (arrows) securing the starter.
	5. With the terminal 50 of the traction relay Remove the electrical connector (arrow). Disconnect the 30 (indicated by arrow) of the traction relay.
6. Remove the starter.

Setting

PERFORMANCE ORDER

1. Set the starter and secure with nuts, having tightened their moment of 60 Nm.
	2. Connect the cable to terminal 30 (1) and tighten the nut to 13 Nm wire (2 - 50 Terminal 3 - terminal 15A, 4 - Connection of the field winding starter).
3. Connect the electrical connector terminal 50 starter (3).
4. Secure the bracket to the coolant pipe.
5. Establish the bottom mudguard of a motor compartment.
6. Connect the ground cable to the battery.