Information display

Switching the information displayed on the display (Fig. 1.27) by pressing the button II (Fig. 1.28) on the switch of a cleaner and a windscreen washer with the ignition.

The information in the on-board computer is stored in two memory blocks "MFA 1" and "2 MFA". Depending on the type of data displayed on the display, the storage unit number is displayed.

Information separate trip after the ignition is switched off and before it is stored in the memory block ?�MFA 1" on-board computer and includes information on travel time, distance traveled and fuel consumed. Based on these data, the computer calculates the average speed and average fuel consumption.

If the motion is resumed for two hours, and after stopping the ignition is turned off, the data of the previous travel in the onboard computer are saved and the new incoming data are added to them. If the time between trips to exceed two hours, all information in the memory of the onboard computer "zeroed".

The memory block ?�MFA 2" for storing general data on the operation of the vehicle adds and processes the results of individual trips, which total duration is 100 hours, the total mileage - 10 000 km and the total amount of fuel consumed - 1000 l. In case of excess of one of these parameters the block of computer memory erases and starts a new count at zero.

Selection indication data corresponding to the storage unit holds the switch I (see. Fig. 1.28). To delete information from the memory on-board computer, perform the following steps:

- Switch on the ignition;

- Transfer switch I in position "1" or "2" (to select the corresponding memory block);

- Transfer switch I and hold it for one second to the position "0" (next to the start position of the corresponding block of memory).

If the display is not the symbol "MFA 1" or "MFA 2", it shows the daily time, even with the ignition off.

Information Display (see. Fig. 1.27) shows the following information:

- The vehicle is moving.

If the switch I (see. Fig. 1.28) is set to "1", the display shows the movement of the car with the ignition on, or the time the "reset" the memory block ?�MFA 1". If the switch I is in position "2" LCD monitor shows the total time of all trips. The maximum total time is 99 hours 59 minutes, at which it starts counting from zero.

- The distance traveled by the vehicle. The information about the distance traveled by the vehicle, prepared analogously to the time information of the vehicle. Maximum total mileage of the car, where the information stored in the memory block ?�MFA 2" of the car is 9999 km. Upon reaching this value data in the onboard computer "reset to zero".

- The average vehicle speed. When the ignition is information about the average vehicle speed is displayed after the passage of the first 100 meters way. Up to this point on it instead of numbers displayed strokes. If the switch I is in position "1", the display shows the current average speed of the vehicle; If the switch I is in position "2" - the average speed of travel.

- The average fuel consumption.

In this mode, data are displayed on the average fuel consumption.

- Motor oil temperature To. The value of the oil temperature is displayed in the range of +50 to +160 ?� C. If the temperature of the engine oil does not reach +50 ?� C, the display instead of numbers displayed strokes. If the oil temperature is above +145 ?� C, it reduces the load on the engine.

- The air temperature outside the car. The value of the air temperature outside the vehicle is displayed in a range from -40 to +50 ?� C. After switching off the ignition of the external temperature data stored in air for 45 min. When resuming motion actual air temperature is received when the vehicle speed of 30 km / h.