printable version
System of stabilization of body
The system will automatically stabilize the body provides a constant quantity of ground clearance (clearance) when the load on the rear axle.
| Fig. 1.45. System of stabilization of the body: 1 - pneumatic shock absorber; 2 - control system; 3 - beam rear axle with stabilizer bar; 4 - the compressor; 5 - stabilizing unit
|
On vehicles equipped with this system (Fig. 1.45), instead of the traditional hydraulic shock absorbers mounted pneumatic 1. They are supplied with compressed air from an electric compressor piston type 2 located in the left corner of the luggage Zaden. The minimum system air pressure - 5 atm.
| Fig. 1.46. Control unit stabilize the body and the compressor: 1 - control; 2 - Valve
|
The control unit 1 (Fig. 1.46) stabilization system installed position of the body with the compressor 2. Operating mode selection system is the switch 3 on the control unit 1. Switch positions 3 modes of the system: 1 - the system is on (manual mode setup clearance); 2 - the system is off; 3 - reduction of the normal clearance of 100 mm (automatic operation of the system); 4 - Normal clearance (automatic operation of the system); 5 - increase the normal clearance of 100 mm (automatic operation of the system). Manual installation clearance (positions 1 and 2) is selected only in the case of a system fault. In automatic mode (positions 3-5) is always kept constant selected value clearance vehicle. The switch must remain in position 4 position 3 and 5 is selected only in extreme cases the operation of a vehicle with a trailer.
|