add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 323 (1985 release)

general info. full specifications. diagnostics. hints. tips. tricks
Mazda 323
Home
 
Mazda
323
Introduction
Gasoline engines
Engine oil
Engine cooling system
Ignition system
The power supply system, the carburettor, fuel injection system
Diesel engine
Exhaust
Coupling
Manual gearbox
Automatic Transmission
Suspension and steering system
Front suspension - general information
Removing and installing strut
Dismantling of an amortization rack / removal and shock-absorber installation / a screw spring
Checking the shock absorber
Removing and installing control arm / replacement of a rubber support
Check / replacement of the support arm / knuckle
Removing and installing drive shaft
Removal and installation of an intermediate shaft
Check / disassembly of the drive shaft / replacement cuffs
Bearing front hub
Rear suspension
Removing and installing the rear spring strut
Dismantling of a back amortization rack / removal and shock-absorber installation / a screw spring
Wishbone / trailing arm / stabilizer
Check the bearing hub
Removal and installation of the bearing hub
Adjusting backlash Bearing Kit
Removing and installing the hub
Steering
Removing and installing steering wheel
Removal and installation of tie rod
Removing and installing steering gear rubber sleeve
Servo pump
Wheel alignment
The values for the test MAZDA 323
Brakes
Wheels and tires, a body, car coloring, care of the car
Electrical system
Heater, illumination system, devices
Controls and operation receptions
Electrical diagrams
 


Hit Counter by Digits


print page printable version

Removing and installing steering wheel



Withdrawal

PERFORMANCE ORDER

  1. Set the wheel in the middle position.
  2. Disconnect earth cable from the battery.

This data is erased from the memory of malfunctions of the engine or a protective code of a radio receiver. Before disconnecting the battery should read instructions in Section Removal and installation of the battery.


  1. Unscrew the bolts pads (key beep) on the back of the steering wheel. Remove the cover.
  1. Unscrew the bolts of the steering wheel using the socket with extension nozzle.
  1. Remove the steering wheel shaft with a suitable puller steering.

Do not apply on the steering column hammer blows, as it is because of this goes.

Setting

PERFORMANCE ORDER

  1. Check that the lever of the direction indicators in the middle position, or when installing the steering wheel can be damaged by the cam.
  2. Push the steering wheel on the spline shaft so that the spokes are horizontal.
  3. Tighten the bolt of the steering wheel with a force of 40 Nm.
  4. Connect the battery earth cable, check the horn.
  5. Perform a test drive and when driving in a straight line to verify the installation of the steering wheel. The spokes of the steering wheel should be placed horizontally, otherwise rearrange the wheel, respectively.
  6. Check the automatic return of the lever the direction indicators.
  7. If available, set the clock and set the security code radio.




« previos page
Steering
next page »
Removal and installation of tie rod

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.