| Home |
| | | Mazda |  | 323 | | Introduction | | Gasoline engines | | Specifications | | Removing and installing engine | | Removal and installation of a gear belt of engines VZ, B5, B6 (SOHC), BP (SOHC) | | Removing and installing toothed belt (DOHC) | | Removal and installation of the cylinder head / cylinder head gasket replacement | | The mechanism of chain drive | | Removing and installing the camshaft / camshaft adjustment | | Removal and installation of a camshaft | | Camshaft / timing gear | | The camshaft / camshaft drive mechanism | | Removal and installation of camshafts | | Removal and installation of valves | | Replacing valve stem seals | | Checking the valve guides | | Chamfering the valve seats in the cylinder head / IT valves | | Lapping Valves | | Checking / adjusting valve clearance | | Compression Test | |  | Removing and installing / belt tension | | Engine oil | | Engine cooling system | | Ignition system | | The power supply system, the carburettor, fuel injection system | | Diesel engine | | Exhaust | | Coupling | | Manual gearbox | | Automatic Transmission | | Suspension and steering system | | Brakes | | Wheels and tires, a body, car coloring, care of the car | | Electrical system | | Heater, illumination system, devices | | Controls and operation receptions | |  | Electrical diagrams | | | |
|
|
|
 printable version
Removal and installation of valves
Withdrawal Setting | - If will be established the old valves and cylinder head, before assembly, check valve guides. If new valves are installed in the old cylinder head must be treated chamfer valves in the cylinder head and the valves themselves.
- Clean the valves with a wire brush and scraper from the remnants of a deposit.
- Engine OT, B5, B6 (SOHC), BP (SOHC): Check the rocker arm shaft and rocker arm for the presence of grooves and wear.
- Lightly grease the valve stem and insert each valve to its old place. New valves should be pre-grind with the help of sanding paste. See Section Checking / adjusting valve clearance.
- Thoroughly clean all parts and lubricate the moving parts with engine oil.
- Be sure to replace the valve stem seals.
- Insert the valves in the cylinder head. Ensure that the intake and exhaust valves were installed in the correct order.
- Insert the lower cup valve springs.
- Install the spring and the upper valve spring cup.
- Compress valve springs with forceps and insert valve crackers so that they fit into the holes of valves. Remove the forceps and install other valves.
- Lightly tap with a hammer on a polymer valve stem to ensure the correct position of crackers.
- Engines with 2 camshafts with top: Lubricate all bucket tappets engine oil and insert them into the holes.
- Install the camshaft. See sections Removing and installing camshaft, Camshaft / timing gear, camshaft / camshaft drive mechanism.
- Replace the cylinder head gasket, install the cylinder head, see. Section Removal and installation of the cylinder head / replacement of the cylinder head gasket.
- Adjust the valve clearance. See Section Checking / adjusting valve clearance.
|
|
|
|
