printable version
Carbureted engines
Fuel pump
Mechanical fuel pump is driven by an eccentric intermediate shaft. Characteristic | Value | The pressure of the vacuum when the starter, kg / cm 2 | 0,332-0,465 | - maximum pressure drop within 1 minute of the engine, kg / cm 2
| 0,095 | Discharge pressure when the starter, kg / cm 2 | 0,25-0,38 | - maximum pressure drop within 1 minute of the engine, kg / cm 2
| 0.05 |
Stromberg Carburetor
On engines and 102,920 M 939 M 115,954 installed horizontal, single chamber with a constant vacuum carburettor Stromberg 175 CDT. Calibration data
Characteristic | Value | Marking the metering pin | UC | Marking the main fuel jet | 100 | Marking the fuel jet of idling | 50 | Marking an air jet idling | 115 | The hole diameter of the needle valve, mm | 2.25 | Marking caps the starting device | 200 | The fuel level in the float chamber, mm | 18-19 | The weight of the float, g | 11,8-13 | Make oil in the damper piston | ATF | The capacity of the shock absorber piston, see 3 | thirty | The thickness of the gasket the needle valve, mm | 15 | Starting backlash air valve, mm | 5,3 ?� 0,3 | Fuel supply accelerating pump for one cycle, sm 3 | 1,9 ?� 0,15 | The engine speed of the engine at the disconnected hose of a vacuum regulator, rev / min | 1250 ?� 50 | The gap between the lever and the adjusting screw vacuum regulator, mm | 0.5 | Engine speed at idle, rev / min | 800 ?� 50 | The carbon monoxide content in the exhaust gas,% | 1,0 ?� 0,5 | The engine speed at accelerated idle speed when the engine oil temperature 75-85 ?� C and position the sector trigger on the 2nd groove profile, rev / min | 1700 ?� 100 | The content of carbon monoxide (CO) in the exhaust gases at rapid idle when the engine oil temperature 75-85 ?� C and position the sector trigger on the 2nd profile slot% | 6 ?� 1 | The time delay of the electromagnetic shut-off valve, with | 6-16 |
Carburetor Solex DVG type 4A1
On engines M 123,920, 123,921 M, M and M 110,923 115,938 installed carburetor Solex DVG type 4A1. Emulsion-type carburettor, two-chamber, with serial opening of the throttle, with the automatic starting device and thermostatic auxiliary starting device (for starting the engine is warm). On the forced idling included economizer overrun. Characteristic | Value | Index carburetors | | E 17481 (E 17703) * | | E 17482 (E 17704) | | E 17603 |
* In brackets the index carburetors installed on models with automatic transmission without a vacuum regulator ignition. ???�???�???�???� ???�?????�?????�?� ?�?�???�???�?�???????�?????? ???�???�?????�?�?????� Solex 4??1. From 1980 model year to change some characteristics of the carburetor Solex 4A1. Characteristic | Value | Fuel supply accelerating pump for one cycle, sm 3 | 0,7 ?� 0,15 | Marking an air jet idling | 125 | Marking spray of the accelerating pump | 50 | Starting backlash air damper, mm | | eleven | | 4,2 ?� 0,2 | Ajar air damper, mm | 0.3-0.8 |
Calibration data Solex carburettor 4A1
Index | Car Model "200" | 1st Camera | 2nd camera | The diameter of the diffuser, mm | 20 | 54 | The hole diameter of the needle valve, mm | 20 | Home metering system | | x 97.5 | B5 * | | 2,147 | 3,747 | The idling | | 42.5 | - | | 120 | - | Accelerator Pump | - fuel supply for one cycle, sm 3
| 0,6 ?� 0,15 | The weight of the float, g | 6,8 ?� 0,35 | Starting clearance, mm | | 3.2 | - | | 4,2 ?� 0,2 | | 2,9 ?� 0,2 | The content of carbon monoxide (CO) in the exhaust gas | 0.5-1.5 | Engine speed at idle, rev / min | 850-950 | Index | Car Model "250" | 1st Camera | 2nd camera | The diameter of the diffuser, mm | 20 | 54 | The hole diameter of the needle valve, mm | 20 | Home metering system | | x 97.5 | B7 * | | 2,147 | 3,747 | The idling | | 42.5 | - | | 115 | - | Accelerator Pump | - fuel supply for one cycle, sm 3
| 0,7 ?� 0,15 | The weight of the float, g | 6,8 ?� 0,35 | Starting clearance, mm | | 3.2 | - | | 4,2 ?� 0,2 | | 2,9 ?� 0,2 | The content of carbon monoxide (CO) in the exhaust gas | 0.5-1.5 | Engine speed at idle, rev / min | 850-950 | Index | Car Model "280" | 1st Camera | 2nd camera | The diameter of the diffuser, mm | 20 | 54 | The hole diameter of the needle valve, mm | 20 | Home metering system | | x 97.5 | B5 * | | 90 | - | The idling | | 42.5 | - | | 110 | - | Accelerator Pump | - fuel supply for one cycle, sm 3
| 0,65 ?� 0,15 | The weight of the float, g | 6,8 ?� 0,35 | Starting clearance, mm | | 3.2 | - | | 4,2 ?� 0,2 | | 2,9 ?� 0,2 | The content of carbon monoxide (CO) in the exhaust gas | 0.5-1.5 | Engine speed at idle, rev / min | 800-900 | | |
* Marking the needle jet.
The solenoid shut-off valve Characteristic | Value | Brand and type | Pierburg PE 20273 | The course of the needle valve, mm | 2,5 ?� 0,05 | Rated voltage, | 12 | The maximum allowable voltage, | 16 | Consumption current when the voltage at terminal 12, A | 0,25 ?� 0,02 |
Vacuum regulator
Characteristic | Value | Brand and type | Pierburg PE 20464 |
A thermostatic valve reduce emissions
Characteristic | Value | Brand and type | Texas Instruments CARP or Pierburg PE 20213 | Valve opening temperature, ?� C | 30 ?� 3 | Valve closing temperature, ?� C | 20 ?� 3 |
|