The glovebox |
1. Remove the bottom two screws and remove the box. |
2. Assemble in the reverse order. |
The lower section of the front of the driver's side |
3. Remove the screws at the top and bottom edges and remove the section from the front panel. |
4. Assemble in reverse order. |
The middle part of the front panel pushbutton switches |
5. Disconnect the battery from weight. |
6. Remove the cover from the gear lever |
7. Remove the screws on both sides of the panel, gently slide it forward. |
8. Disconnect switch and remove the panel. |
9. If necessary, mark the route bundles to the assembly to lay the wiring in place. |
10. The assembly is performed in reverse order. Make sure that the air vents into the corresponding air ducts. |
Facing the steering column |
11. Disconnect the battery from weight. |
| |
12. Remove the bottom 6 screws, remove the bottom cover of the ignition switch (left) and post down, disconnected from the upper latch plates (pictured right). |
13. Turn both levers all the way down and gently remove the top cover. |
14. The assembly is performed in reverse order. |
Cover instrument panel with air vents |
15. Remove the steering column covers. |
16. Remove the two upper bolts and slightly tilt column. |
| |
17. Remove the screws decorative casing dashboard (two on the left, two on the right and one at the bottom (right) and one at the top (left)). |
| 18. Carefully remove the cover from the front panel. If you want to post a column down to the expansion of space. |
19. The assembly is performed in reverse order. Upper column bolts tighten with the set moment. |