Glass |
1. Remove the cover and the screen. |
2. Place the window handle (or connect the socket of the switch, connect the battery to the mass). |
3. Lower the window so that the bolt of the glass appeared in the opening frame of the door. |
| 4. Supporting the glass, remove the screws to the glass holder (indicated by arrows). In cars with coupe has an additional bolt of glass to the front of the guide roller. |
5. Remove the glass through the opening. |
6. Glass is installed in reverse order. When installing, take care to keep up with the seal. Before installing the panel, check the operation window. |
Windows (hatchback and sedan) |
1. Remove the glass from the window (see. |
2. Raise the window and secure with tape or wedges, or remove. |
3. Disconnect the electric drive (if available). |
| 4. Remove the bolts hand drive window (or electric) (indicated by arrows). |
| |
5. Remove the upper (left) and bottom (right) window regulator screws and remove the control over the window opening. Power gets to the ropes with the regulator. Pre-mark the location of the detachable parts. |
6. The assembly of glass with the controller and the drive is installed in reverse order. Before installing the panel, check the operation window. |
Coupe |
1. Remove the glass from the window. |
2. Disconnect the drive. |
3. Remove the screws of the electric window. |
4. Remove the screws on both rails and remove the window regulator assembly. Pre-mark the location of the detachable parts. |
5 of glass is installed in reverse order. Before installing the panel, check the operation window. |
Small tailgate window - 5 door hatchback |
1. Remove the lift section of the window. |
2. Remove the bolt and the rear guide, keeping the area. |
3. Carefully remove the seal from the area. |
4. Remove the seal from the corner. |
5. Corner is set in reverse order. |