1. Disconnect the battery from weight. |
2. Remove the inner door panel (see. Subpart 13.11). |
3. Disconnect all connectors, mark the route of the wiring and remove the brackets. |
4. Carefully pull the wiring of the door opening, pulling seals. |
| 5. Knock-axis limiter door opening. |
6. Mark the position of the hinges on the door. |
| 7. While supporting the door, unscrew the hinge screws and remove the door. |
8. Check the condition of the loop, if necessary, replace by removing the screws on the body. |
9. Flap Clutch. |
10. Lower the clutch housing bolts to the engine block. |
11. The door is installed in reverse order of labeling. Replace the axis of the stopper. If necessary, adjust the door. |