Facing panel in niche driver's footwell |
1. Insert and remove the cover, remove the screws. |
2. Turn and pull back the lock, remove the panel. |
3. Install the panel in the reverse order. |
Nut Covers |
4. Remove the frame seal, pry the cover to release the latch. |
5. When installing the cover, push until it clicks. |
Cover pillar |
6. Remove the door seal, pry up and remove the cover. |
7. When reassembling, carefully insert the door seal. |
The inner door panel |
8. See. Subsection 13.11. |
Rear shelf (sedan) |
9. Remove the rear armrest. |
10. Remove the two plastic tabs on the front of the tray flange. |
11. Pry up the rear shelf and remove the tray. |
12. If necessary, you can remove the shelf assembly by undoing the lower seat belt bolt and thread the strap through the hatch shelves. |
13. Install a shelf in reverse order. |
The inner lining of the trunk (sedan) |
14. To remove the back cover, remove the seal and post panel up by disconnecting the clips. |
15. Flooring trunk mounted plastic clip. Remove the bracket mounting tapes and the ceiling, and then remove the mats. |
16. The assembly is performed in reverse order. |
The inner lining of the trunk (coupe and hatchback) |
17. Remove the plastic cap and unscrew 4 screws that secure the rear panel. |
18. Flooring trunk is removed as follows. |
19. Lift the rear part of the floor. |
| 20. Hook and remove the latch from the rear of the deck body. |
21. The assembly is performed in reverse order. |
The inner lid panel (sedan) |
22. Hook and remove the plastic tabs, remove the panel from the brackets in the rear cover and remove. |
23. The assembly is performed in reverse order. |
The inner lining of the cargo compartment (hatchback) |
| |
24. Hook and remove the plastic tabs, remove the screws. Carefully trim panel forked post puller, pulling latch, hidden under the rear panel (left) and remove the trim panel (pictured right). |