printable version
Camshaft - removal and installation
Withdrawal 1. Remove the cylinder head.
| 14.4a Hold camshaft for deepening ... |
| 14.5a Removing camshaft oil seal |
| 14.6 Checking camshaft axial clearance 1. Indicator 2. Luft 3. Bolt 4. Camshaft 5. Thrust Washer |
| 14.7 Thrust washer to adjust the axial play of a cam. It delivered in parts with the specified thickness (in brackets the size in mm). 1. With Label 2. Without tags 3. punching 4. To the side of the engine |
| 15.1 The surface of the camshaft bearings |
| 15.2 Measurement of neck support |
| 15.3 Checking camshaft runout |
| 15.4 Checking the wear of the camshaft cams |
2. Remove the tappets with the housing and rollers with a yoke. 3. Remove the end cap (see photo). 4. Hold the camshaft, unscrew the central bolt (see photo). Remove the bolt and washer. 5. Carefully remove the gland and the camshaft (see photo). Setting 6. Grease basic necks and install the camshaft. Tighten the bolt and check the axial clearance (see photo). The backlash should be 0.03-0.06 mm. 7. If the backlash exceeds norm replace the thrust washer (photo).
| 15.5 Validated surface hydropusher |
| 15.6a Check diameter pusher ... |
|