printable version
Sump -snyatie and installation
1. Disconnect the battery from weight.
| 15.86 Measure the diameter of the holes in the yoke. |
| 15.6b ... and pusher holes in the body I |
| 15.8a roll diameter is measured at the position of the rocker arm |
2. Lift the front of the car and establish on supports. 3. Remove the shield and drain the oil sump. 4. Remove the starter. 5. Remove the bracket to the engine bell housing. 6. Remove the idler arm. 7. On 4x2 vehicles, remove the stabilizer brackets. 8. On 4x2 vehicles, remove the subframe. 9. On 4x4 vehicles, remove the arm of a forward gear.
| 16.17a Apply sealant in place of the rear oil seal fit and oil pump |
| 16.17b Places applying sealant to the sump gasket 1. Laying |
| 17.3a bolts of the oil pump |
10. Remove the transmission support. 11. Disconnect from the exhaust manifolds. 12. hang out the power unit on the hoist or set the jack under it. 13. Remove the bolts from the engine mounts to the frame. 14. Slightly raise the engine, being careful. 15. Remove the bolts and remove the pan. 16. Thoroughly clean the split plane of the cylinder and the pallet of the consolidation rests. Banish and clean the threaded holes in the engine block. 17. Apply sealant to the split plane (photo). 18. Place the gasket on the tray, set the pan and evenly crosswise tighten the bolts to the specified torque (see photo).
|