printable version
Cylinder head cover - Removal and installation
1. Complete decompression of the fuel system.
| About 3.4a mark on the pulley and the pointer |
| When the division of about 3.4b on a pulley aligns with the index ... 1. The scale installation of ignition |
| 3.5 ... and the slider indicates labeling, the piston of cylinder 1 is in the compression stroke TDC 1. Rotor |
2. Disconnect the battery from weight. Right Cover 3. Disconnect the hose crankcase ventilation (photo) 4. Mark and disconnect the wires from the candle, take them aside. 5. Remove the cap from the hoses and wires. 6. Remove the cover screws and washers. | 4.3 hoses and wires that must be disconnected in order to remove the right cylinder head cover |
| 4.8 hoses and cables that must be disconnected in order to remove the left cylinder head cover |
| 5.3 Place the roller screws to the cashier in the order they install |
7. Remove the cover by carefully opening the seal. Left cover 8. Remove the cover from the breather hose (photo). 9. Designate and disconnect the wire from the spark. 10. Remove the wire from the bracket. 11. Remove the 9 screws and remove the cover. Setting 12. Clean the cover from the remains of seals, apply the sealant into the groove of the lid and place the gasket. After setting sealant replace the cover and tighten the screws. 13. Tighten the screws to 3-4 hours. 14. The rest of the procedures are performed in reverse order. 15. Warm up the engine and check for leaks
|