printable version
Cylinder head - removal and installation
1. Complete decompression of the fuel system, disconnect the battery from weight and sing liquid.
| 12.4 Tags th and L on two sprockets distribution fishing) |
| 12.5b Pressing gland (using the same tool as for the crankshaft oil seal) |
| 13.3 Bolts back cover of a gear belt |
2. will remove the toothed belt, the valve body, suction-binding manifold, camshaft sprocket. 3. To turn away bolts and remove the back cover of a belt (photo). | 13.7a Procedure for releasing cylinder head bolts 1. To the front of |
| Bolt 13.8 at the bottom of the cylinder head |
| 13.14a Orientation washers Cylinder Head 1. In the side of the head |
Removal of the left head 4. Remove the compressor and take aside, without disconnecting the line. 5. Remove the distributor, generator, alternator bracket and the exhaust manifold. 6. Remove the valve train parts. 7. Evenly and gradually loosen the cylinder head bolts and store them in the original order (photo). 8. Remove the small screw at the bottom of the head (photo) and carefully remove the head. The right head 9. Remove the power steering pump and take aside.
| 13.7b One way to store the pattern bolts on the cylinder head gasket (can be removed with a new gasket). Designate a front portion and the right and left sides of the cylinder head |
| 13.13 Orient lining of the pins on the cylinder block |
| 13.14b Order of a tightening head dangles. Bolts 4,5,12 and 13 longer than the others 1. The right head 2. Left head |
| 14.4b ... unscrew the central bolt |
10. Remove the exhaust manifold, valve train parts and remove the cylinder head bolts (see. Above). 11. Remove the small screw at the bottom of the head and carefully remove the cylinder head Setting 12. Thoroughly clean the split plane of the block and heads, small bumps grind, run and clean all threaded holes. 13. Place a new gasket on the block (see photo). 14. Wrap the hand of the cylinder head bolts in place. The flat part of the bolt washers must face toward the cylinder head (see photo). 15. Tighten the bolts in 5 steps with the set moment in the specified sequence (see photo). 16. Other operations are performed in reverse order. Change the oil and filter.
|