REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Golf IV (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Golf 4
		Instructions
		Engine
		Cooling system
		Fuel System
		Exhaust system
		Ventilation and heating system
		Coupling
		Transmission
		Suspension brackets and power shafts
		Steering
		Wheels and tires
		Brakes
			Technical specifications
			ABS / EBV / EDS / ASR / MSR
			Replacing the front brake pads on support FS-III
				Withdrawal
				Setting
			Replacing brake pads on a support FN-3
			Replacing the rear brake pads on disc brakes
			Brake disk
			Adjusting handbrake
			Replacing the rear brake pads Drum brakes
			Removing and installing rear working brake cylinder
			Bleeding the hydraulic brake system
			Brake pipelines and hoses
			Check the brake servo
			Removal, installation and adjustment of brake light switch
			Removal and installation of cables of a manual brake
			Key brake failure
		Body
		Electrical equipment and wiring

printable version

Replacing the front brake pads on support FS-III

Front brake caliper FS-III

1 - Phillips head screws 4 Nm;
2 - Disc. In need of replacement replace both front brake discs. Before removing the brake disc caliper must be removed;
3 - the brake pads. It is necessary to change all brake pads on the same axle of a vehicle;
4 - support;
5 - a directing bolt, 28 Nm;
6 - a protective cover;
7 - the brake hose with a tip of the hollow bolt to 35 Nm. When replacing the brake pads do not need to unscrew the brake hose;

8 - the knuckle;
9 - Allen screw;
10 - gauge ABS. Before installing, clean the bottom internal thickening and lubricate it with grease VW-G000650;
11 - partition;
12 - a bolt, 10 Nm;
13 - wheel bearing;
14 - a lock ring;
15 - wheel hub with ABS sensor rotor

Caliper FS-III is characterized in that a single item.

PERFORMANCE ORDER

A warning Be sure to make replacement of all pads on one axis of the car even if deterioration borders were reached only one shoe. If the brake pads will be repeatedly established, before removal they are necessary for marking.
1. Loosen the bolts of the front wheels, then lift the front of the car and fix on supports.
2. Remove the front wheels.
	3. Remove the protective cover (1) with two guide bolts of the caliper. Using the Allen wrench, unscrew bolts of a support guide.
	4. Remove the caliper and, without disconnecting from it a brake hose, soft wire tie him to the car body. It does not pull or twist the brake hose.
5. Remove the caliper brake pads.

« previos page
MSR. The system lock prevents the drive wheels

next page »
Withdrawal